PROS TECHNOLOGY TOTAL DISPENSING SOLUTIONS – DISPENSING SYSTEM
Adhesive precise control is closely related to our lives together with continuous industrial growth and will be applied in various ways for the production process, contributing to higher productivity and reliability with precision and a lot of application technologies
Pros Technology – Expert in specialty materials & dispensing solutions.
➤ #Hotline: (+84) 984 695 398
➤ Email: firstname.lastname@example.org
The adhesive control technology is various to the physical properties, adhesive characteristics of materials dispensed. Therefore the manufacturer should know the properties and viscosity of liquids, the amount and pattern of dispensing, working method to look for the suitable dispensing system to each application.
However, every application should comply with the following basic dispensing system in order to improve productivity and reduce manufacturing cost:
1.Pump: help to dispense adhesive with high quantity within 5-gallon pail can or more.
2. Controller TAD: using the principle of inserting air into the liquid surface, to precisely control output by selecting time, pressure, needle size where the minimum level can be down to 0.0001cc.
3. Valve: The most important and complex part of the dispensing system. This component helps to optimize the minimum quantity of low viscosity adhesive. This kind of high precision dispensing valve can control the dispensing capacity by a flow sensor, so as to save materials and bring high product quality.
There are many types of valve suitable for different applications:
■ Diaphragm Valve: used for low viscosity materials like: Chemical, UV Coating, Anaerobic/ Instant Adhesive, Epoxy, Silicone, Medical Liquid.
■ Needle off Valve (Spray): used for low viscosity materials like: Flux, Oil, Ink Grease
■ Needle off Valve (Precision): applied in the application has a high-standard requirement about precision when dispensing the materials with middle or low viscosity as Silicone, Epoxy, UV Coating, …
■ Metering Valve
■ Suck back Valve
■ Actuator Valve
■ Jetting Valve
■ Dot Valve
4. Pressure Tank
■ These pressure tanks are used as containers of materials.
■ Various container sizes (1L~50L) makes fluid inventory control easy.
■ Containers can be modified using standard accessory options (electropolishing and Teflon coating).
■ Custom tanks can be designed and built to meet material, design, and volume requirements.
■ Accessory options for tanks, Special tanks can be built.
– Under Filling
– HIC Sealing
– Epoxy Potting
– C.O.B Sealing
– UV Bonding
– UV Sealing
– Silver Paste Bonding
– Two-part adhesive Molding
– EMI Sealing
– Gasket Sealing
– Grease Filling
– EL Sealing
– LED Molding
– Key-pad Bonding
– Solar module junction box sealing
– Bio sensor, Micro jet
This application is used in many industries, including:
– Display product
– Solar energy industry
– Radio communication product
– Electric industry
– Electronics industry
– Automotive industry
– Bio Industry
– Space airline industry
– … etc
There are many types of dispensing systems because of the different combinations of its components. Contact us to receive the most appropriate system with your demands.