MXLOC 48 is designed for the bonding of cylindrical fitting parts. The product is a single component anaerobic, acrylic based product. The product cures when confined in the absence of air between close fitting metal surfaces and prevents leakage and loosening from vibration and shock. Applications of MXLOC 48 include holding sprockets and gears into gearbox shafts and rotors on electric shafts.
DIRECTIONS FOR USE:
For optimum performance surfaces should be clean and free of grease (internal and external).
If the material is an inactive metal consider using activator.
Assemble and tighten as required.
For shrink fitted assemblies the product should be applied onto the pin, the collar should then be heated to create clearance for free assembly.
For slip fitted, apply product inside of the collar then to the leading edge of the pin, then use a rotating motion in assembly to ensure coverage.
For press fitted, apply product to both surfaces making sure of assembly at high press rates.
FOR DISASSEMBLY:
In circumstances where hand tools do not work, use localized heat to bolt or nut, disassemble while hot.
FOR CLEANUP:
To remove cured product use a combination of solvent and abrasion such as a wire brush.
PRECAUTION:
Use with proper ventilation. Avoid contact with skin and eyes.
If contact with skin occurs, rinse with warm water or dissolve gradually with appropriate debonder.
Do not try to remove forcibly.
If adhesive gets into eye, keep eye open and rinse thoroughly. Seek medical attention immediately.
Keep well out of reach of children.
STORAGE:
Keep adhesive in a cool, dry place optimal storage 8°C-21°C, is recommended unless otherwise labelled. To prevent contamination of unused material, do not return any product to its original container.
