ET5104 is a two component, easy to use, epoxy based tile adhesive and grout. It is suitable for all types of tiles and stones on the floor and wall. It is especially recommended for hygiene-sensitive areas and also areas that require sterile conditions.
When mixing two components, it forms a smooth, creamy & thixotropic paste, which is easy to apply, easy to clean, and easy to maintain. At the same time, it also provides high mechanical and chemical resistance properties. The resultant is, an easy to-use, high-durability grout, which is available in an attractive range of colors.
Features
For grout joints between 2 mm – 12 mm.
Easy to mix, creamy consistency high productivity grout.
Can be applied on wall and floor.
Highly thixotropic – non-sag formula can be used as both grout and adhesive on floor & wall.
Easy to apply
Early flexural properties
High resistance to abrasion
High Compressive strength
Low water absorption results in watertight joints
Resistance to stain & chemicals.
Hygienic in service & would not allow bacterial growth
Low VOC – Over curing full reaction takes place.
Available in 12 widely used colors.
Properties
ET5104
Physical State
A – colored resin paste
B – Neutral color hardener paste
Pot life
> 80 min, 25°C
Full cure
7 days
Temperature range
0°C – 80°C
Mix density
1.58 g/cc
ANSI 118.3 SPECIFICATION
Classification Code
Test Characteristics
As per ANSI
ET5104
Water cleanability
Spreadable and cleanable after mixing
80 min
95 min
Setting time
initial setting time
>120 min
175 min
Service setting time
<7days
6 days
Shrinkage
After 7- day cure
<0.25%
0.06%
Sag in vertical joints
In 10 mm tile gap
No change
No change
Bond strength to quarry tile
Shear bond strength after 14 days
>6.9 MPa
8.5
Compressive strength
After 7 days
>24.2 MPa
33
Tensile strength
After 7 days
>6.9 MPa
8.7
Thermal shock resistance
Shear bond strength immersion and hot and cold water bath
