3M™ Low VOC Double Coated Tape 9599 has a non-woven tissue carrier with acrylic adhesive on both sides. It provides high adhesion to a wide variety of materials and is suitable for automobile interior applications
FEATURES
- VOC analysis (micro g / pcs): measured at external organization which is approved by
Formaldehyde: 0.07
Acetaldehyde: 0.07
Toluene: 0.11
Xylene: 0.02 Ethylbenzene: ND Stylene: ND Tetradecane: 0.03 Dibutyl phthalate: ND
Di-2-ethylhexyl phthalate: ND
Sample Size: 80mm x 100mm/pcs
Dwell Temp: 149°F (65°C)
Dwell Time: 120 minutes
Gas trapping volume: 4L with Tedlar bag
Absorption pipe: Tenax-TA, DNPH cartridge
Absorb air in tedlar bag with each absorption pipe after heating and measure with gas chromatograph mass spectrometer or high speed liquid chromatograph.
APPLICATIONS
- Bond strength is dependent upon the amount of adhesive-to-surface contact developed. Firm application pressure helps develop better adhesive contact and improve bond strength. 15 psi momentary pressure is typical.
- Ideal tape application temperature range is 70°F to 100°F (21°C to 37°C). Initial tape application to surface at temperatures below 50°F (10°C) is not recommended because the adhesive becomes too firm to adhere readily. However, once applied, low temperature holding is generally satisfactory. Surfaces should be clean and dry prior tobonding. We recommend a final surface cleaning with a mixture of 50% isopropyl alcohol and water.
Typical Physical Properties
|
Attribute Name |
Test Method |
Value |
|
Adhesive Type |
|
Acrylic |
|
Total Tape Thickness |
ASTM D3652 |
0.114 mm (4.5 mil) |
|
Liner Print |
|
Low VOC |
|
Liner |
|
PCK |
|
Liner Thickness |
|
0.11 mm (4.5 mil) |
Typical Performance Characteristics
|
Attribute Name |
Test Method |
Value |
|
90° Peel Adhesion |
ASTM D3330 |
9.9 N/cm (91 oz/in) ¹ |
¹ 12 in/min (300 mm/min)
|
Attribute Name |
Value |
|
Short Term Temperature Resistance |
121 °C (250 °F) ¹ |
|
Long Term Temperature Resistance |
93 °C (200 °F) ² |
Available Sizes
|
Attribute Name |
Value |
|
Available Width |
1/40 in |
|
Core Size (ID) |
76.2 mm (3 in) |
|
Maximum Length |
10 to 100 yd |
|
Normal Slitting Tolerance |
±1/16 in |
|
Note |
Subject to Minimum Order Requirements |
|
Precision Slitting Tolerance |
-0 to + 1/16 in ¹ |
